1. Home
  2. Blog
  3. Seawater treatment plant for hotels and resorts

Desalination

Seawater treatment plant for hotels and resorts

How a seawater treatment plant for a hotel or resort works: demand peaks, treatment stages, concentrate permits, redundancy and what to send for a quote.

AFG Dubai Engineering · · 4 min read

Many hotels and resorts on the coast, on islands and in remote locations produce their own water from the sea. A seawater treatment plant on site gives the hotel control over its supply for guest rooms, kitchens, laundries, pools and landscaping. This article explains how a seawater treatment plant for a hotel or resort is put together, what decides its size and what the operator should plan for, with examples from AFG's own hotel references.

Why hotels build their own seawater plant

A hotel or resort may have no network connection, a connection that cannot meet the demand of a new development, or a location such as an island where bringing water in by pipeline or tanker is impractical or costly. In these cases a seawater desalination plant, usually seawater reverse osmosis (SWRO), becomes the main water source. Some resorts also run one alongside the network to secure supply in the peak season.

How hotel water demand behaves

Hotel demand is not flat. It follows occupancy, which changes with the season and with events, and it follows the day: showers in the morning and evening, kitchen and laundry peaks, and irrigation that often runs at night. Pools, spas and landscaping can add a large share on resort sites. The plant is sized for the design daily demand, while storage covers the hourly peaks so the membranes run steadily rather than following every change in use.

Not all of that water needs drinking quality. Irrigation and some utility uses can sometimes be supplied from another source, such as treated greywater, which lowers the capacity the seawater plant must deliver.

The treatment stages

A seawater treatment plant for a hotel follows the same stages as a larger desalination plant, at a scale that fits the site. Our guide to how a desalination plant works follows the water step by step. In short:

  • Intake: seawater is drawn through an open intake line or beach wells. Beach wells give naturally pre-filtered water where the ground allows them.
  • Pre-treatment: an automatic backwash filter removes coarse particles, followed by sand filtration and, where the seawater quality calls for it, ultrafiltration. Cartridge filters give the final protection.
  • High-pressure pumps and SWRO membranes: the pumps raise the pressure so that water passes through the membranes while dissolved salts stay behind. Energy recovery devices can return pressure from the concentrate to the feed and cut power use.
  • Post-treatment: the permeate is remineralised, for example over dolomite, its pH is adjusted, and it is disinfected with UV and chlorine before storage.
  • Storage and distribution: treated water goes to storage tanks sized for the daily peaks, then to the hotel network.

What AFG's hotel plants look like

The reference projects on this site include three five-star hotel seawater plants in Türkiye. The plant in Serik produces 1,200 m³/day with a self-cleaning filter, ultrafiltration, SWRO, dolomite remineralisation, sand filtration and an RO stage. The plants in Bodrum, at 1,000 m³/day, and Kuşadası, at 360 m³/day, use a self-cleaning filter, sand filtration, SWRO and dolomite. Each was engineered around its own seawater and demand; the seawater desalination page describes the range.

Concentrate and permits

An SWRO plant returns a concentrate stream to the sea that is saltier than the feed. Its discharge point, dilution and any monitoring are set by the environmental approval for the site, alongside the permission for the intake. These approvals can take time, so they should be started early in the project, together with the choice of intake and outfall locations.

Space, noise and appearance

Guests should not notice the plant. High-pressure pumps and blowers are noisy, so the plant room or container is placed away from guest areas, with acoustic treatment where needed. Where a resort has no suitable building, a container can be a practical answer; containerised RO plants explains when it makes sense. Access for chemical deliveries and membrane replacement is part of the layout.

Reliability and redundancy

A hotel cannot run without water, so many plants are built with two or more trains, so that one can be cleaned or serviced while the other keeps producing. Storage that covers a period of production adds further margin, for example in sectional modular water tanks. Spare cartridges, chemicals and critical parts should be held on site.

Operation by the hotel team

A seawater plant needs daily checks, chemical management, cartridge changes, membrane cleaning and regular water testing. PLC automation and remote monitoring reduce the workload, and operator training at handover matters, since the hotel's engineering team runs the plant day to day. Service and spare parts support should be agreed before the plant is ordered.

What to send for a quote

  • The number of rooms, the facilities and the expected occupancy, or the design daily demand.
  • Which uses must be drinking quality and which can use other water.
  • A seawater analysis, or at least the intake location.
  • The space available for the plant and the storage, and the power supply.
  • How the concentrate will be discharged.

With these details AFG can propose a plant design. The seawater desalination systems page in the catalogue shows the components AFG builds.

FAQ

Questions buyers ask

What size of seawater plant does a hotel need?
It depends on the number of rooms, the facilities, the occupancy and which uses need drinking quality water. AFG's hotel references on this site run from 360 to 1,200 m³/day, but every plant is sized from its own demand.
Does a hotel seawater plant need ultrafiltration?
Not always. It depends on the seawater quality and the intake. Some AFG hotel plants use self-cleaning and sand filters only, while the Serik plant adds ultrafiltration. The seawater analysis decides.
Is desalinated water from a hotel plant safe to drink?
After post-treatment, which means remineralisation, pH adjustment and disinfection to the required standard, it is used as drinking water. RO permeate is not supplied straight from the membranes.
Can a hotel seawater plant be installed in a container?
Yes, where there is no suitable plant room. The container provides the room, and the site provides a level base, the water connections, power and the concentrate line.

Request a quote

Ready to talk about your water?

Capacity and source water are enough to start. A full analysis lets our engineers choose the right membranes and pre-treatment.

Emailinfo@afgdubai.aePhone+971 54 218 4086WhatsAppChat on WhatsApp
Address in DubaiSilver Tower, Office 2102, Business Bay, Dubai, UAE